Hi there,
I’m running a desktop windows 7 32. Bit. Multi core processor, stand-alone video card and printer express port card With a LPT port breakout board.
If wondering if I tell my tool to run at 2000 mm/min and in my ports and pins under motor tuning I have the motors speed set to 1998 mm/ minute will this cause miss-Steps every once and a while?
I use Fusion360 to design and make the tool paths gcode. I bumped up my cutting speed from 1900 to 2000 recently. Im missing steps as much as a deviation in one shot of 10mm
Right when my tool path changes from a 3D Adaptive clearing to a 3D ramping tool path.
Thanks
Glen