Ok so take it you have a wire from terminal 10 on BOB going to one terminal 1 on first switch then terminal 2 on that switch goes to 1 on next then 2 on that switch goes to the Gnd connector beside terminal 10?
If so then you should get a change in LED state of M1++ M1-- M1 home LEDs on the diagnostics page when you press any of the switches on the X axis. If you dont then possibly they are normally Open switches and in that case you will not get anything unless you press both switches at the same time. Hood
Ok thanks, I am thinking it may be 022 or before that is needed, seems to after that version that a lot of things got screwed up. Dont suppose there is a chance of you trying 022? Hood
Sounds like you may be getting noise from the drives. Is this servo or stepper? What kind of drives? Have you got the E-Stop and Limits wiring shielded and correctly grounded? Hood