Well, the problem I'm having is when trying to simulate known good code (I've cut real parts with it...), it executes a few lines, then dies with a crytpic error:
"Radius to end of arc differs from radius to startLine 18"
Here's the pertinent part of the G-code:
N0000 (Filename: Jag bracket2 Mill.nc)
N0010 (Post processor: My Mach2 2D.post.txt)
N0020 (Date: 8/24/2008)
N0030 G20 (Units: Inches)
N0040 G40 G90 (Cancel Cutter Diameter Compensation, Absolute Distance Mode)
N0050 F1
N0060 (Part: Jag bracket2)
N0070 M00 (Process: Outside offset Perimeter, Mill/Router, 0.5 in diameter, 0.125 inch Deep)
N0080 M00 (Insert Mill/Router, 0.5 in diameter)
N0090 T0 M06 G43 H0 (Change Tool, Set Tool Length Offset)
N0100 M03 S35 (Spindle CW)
N0110 M00 (Set Z to 1.0000)
N0120 G00
N0130 X-0.0175 Y5.1254
N0140 G01 F1
N0150 M00 (Set Z to -0.0625)
N0160 G03 X0.3483 Y5.3919 I0.0496 J0.3161 F2.25
N0170 G02 X0.5886 Y5.6187 I0.2667 J-0.0419
N0180 G03 X1.6176 Y5.8453 I-0.4349 J4.4249
N0190 G02 X4.7371 Y6.4722 I3.2187 J-7.9414
N0200 X4.7391 Y6.4722 I0.0031 J-0.2700
Regards,
Ray L.