I've tried so many combinations that I'm lost
I would like to know what I must do to home it right.
I have two limit switch, one for the X and one for the A axis, both have there own input, port 2 pin 15 and port 2 pin 11 (on diagnostic screen, I can see both led when I manually trigger the switches, it is OK)
If I disable one limit switch, homing is OK but not square
If I enable both switch, homing is ok but look like Mach3 does not see the switch for the A axis. it will not square the gantry
On general config, I try to enable and disable "home slave with master" and this does not work either
I try to edit the RefAll button, with the Refcombination(9), this does not work, homing is good but not square, look like Mach3 does not see the A switch, Act like the DoButton (23) Ref X
One wire of the switch is connected to +5 and other is connected to input of the breakout board (did the autoselect and Mach3 recognize both switches.)
Do I have to Ref A axis separately, what is the DoButton code?
I'm using Mach3 V 3.042.001
I really don't know what else to try after that. I have searched on the forum with no result. Thanks