8949
« on: April 08, 2012, 06:31:27 PM »
Without looking up oems etc it would see that macro is to set a work offset up, that is a totally different thing from homing alone.
Homing to a switch will set DROs zero and then if moving to a position and your steps per unit dont allow that exact position then Mach will move as close as it can. Unless your steps per unit are very course then that would not matter as it would be a very small amount, add to that the fact that Mach will keep track to I think 16 decimals then the moves are not rounded as any following moves will take into account the previous small shortfall.
Hood