461
General Mach Discussion / Re: Odd glitch in movement?
« on: April 29, 2014, 04:34:54 AM »Question - as it is I now know it will work at 3300mm.min on 1mm sheet very nicely. If I then go for thicker metal, say cutting at 700mm.min, will the acceleration have less 'bite' than it does at this higher speed.?
Not sure what you mean by "bite" but if you mean "jerk" then...
(Jerk is not just an arbitrary term btw - it's the pukka name for the rate of change of acceleration).
As acceleration is constant in Mach - so is Jerk. (There used to be a planner that used S-curve accel to reduce jerk - but that's another story).
Or to put it another way - any lack of rigidity presents the same issues at any speed.
Not sure if that answers your question.