3571
General Mach Discussion / Re: Tachus42 Drivers and motors works in Kcam 4 and Not working in Mach3
« on: December 22, 2013, 02:38:40 PM »
I dont see any reason it would not work as the motor pins are the same in that xml as the screenshots of KCam.
You do not have Sherline mode enabled in that xml however but maybe you changed it back?
When you changed to Sherline mode did you restart Mach?
Hood
You do not have Sherline mode enabled in that xml however but maybe you changed it back?
When you changed to Sherline mode did you restart Mach?
Hood