1931
Mach4 General Discussion / Re: Mach 4 Feature Request
« on: June 01, 2014, 01:34:25 AM »
Things to consider for a NEW tool table.
Tool # , Slot#, Diam, Height, Flute#, Type, Desc, DiamWear, HeightWear, ToolLife, ToolTime, %T_Life
Tool # = Tool #
Slot# = Position in Tool changer
Diam = Tool Diam
Height = Tool Height Offset
Flute# = # of flutes used for tool load calculations
Type = Type of Cutter used to bring up Picture of tool
Desc = General description of tool
ToolLife = How long the tool will last in UNITS Minutes, Holes drilled or tapped, etc
ToolTime = How long in UNITS has the tool ran sense installed
%T_Life = what percent of tool Life is left
(;-) TP
Tool # , Slot#, Diam, Height, Flute#, Type, Desc, DiamWear, HeightWear, ToolLife, ToolTime, %T_Life
Tool # = Tool #
Slot# = Position in Tool changer
Diam = Tool Diam
Height = Tool Height Offset
Flute# = # of flutes used for tool load calculations
Type = Type of Cutter used to bring up Picture of tool
Desc = General description of tool
ToolLife = How long the tool will last in UNITS Minutes, Holes drilled or tapped, etc
ToolTime = How long in UNITS has the tool ran sense installed
%T_Life = what percent of tool Life is left
(;-) TP