1471
General Mach Discussion / Re: Losing Config's After Computer Re-Starts
« on: May 15, 2019, 01:27:21 AM »
Just throwing in ideas...
The on-screen shortcut to Mach3 may be calling a different profile to the one you were last using.
Go into the Mach3 folder and double click the Mach3 application – this should bring up a list of current profiles – if there is more than one then try each until you find the correct one – note the profile name that works and change your desktop shortcut properties to the new profile name (note there is a space between the /p and the name).
Tweakie.
The on-screen shortcut to Mach3 may be calling a different profile to the one you were last using.
Go into the Mach3 folder and double click the Mach3 application – this should bring up a list of current profiles – if there is more than one then try each until you find the correct one – note the profile name that works and change your desktop shortcut properties to the new profile name (note there is a space between the /p and the name).
Tweakie.