2601
Mach3 and G-Rex / Re: start points??
« on: June 15, 2012, 06:55:05 PM »
Larry,
In Cambam you can change the start point from where you located the profile relative to the drawing origin.
Scroll down the properties listing and you will see START POINT. Also have a look at the Cambam Manual and their site videos.
RICH
In Cambam you can change the start point from where you located the profile relative to the drawing origin.
Scroll down the properties listing and you will see START POINT. Also have a look at the Cambam Manual and their site videos.
RICH