Machsupport Forum
Mach Discussion => Mach4 General Discussion => Topic started by: Thinder on July 01, 2019, 06:05:58 PM
-
Hi all.
For some reason my tool table and my offset table wont display. I click it and it shows is displayed down on the tool bar but i cant get it to display. even when i roll over it, it shows it as a blank page. THis is the first ive seen of this
-
Most likely the window is positioned by the developer to display on another screen in a dual screen system.
to move it where you want: https://www.technipages.com/bring-off-screen-window-back-onto-screen