611
General Mach Discussion / Re: mach3 material thickness
« on: April 04, 2017, 04:42:42 PM »
If you are using the any of the wizards you will define it in the wizard.
If you are using LazyCam then you define it as part of the tool definition. See Tutorial #6 page 100
of the LazyCam Manual available in Members Doc's.
Read the LC manual and don't hack the program as everything that I know about LC is in the manual!
RICH
If you are using LazyCam then you define it as part of the tool definition. See Tutorial #6 page 100
of the LazyCam Manual available in Members Doc's.
Read the LC manual and don't hack the program as everything that I know about LC is in the manual!
RICH