9653
« on: January 17, 2012, 05:59:45 PM »
I found index debounce of 0 was best for me when I used optos and even 1 would screw the speed up. Suppose it all depends on your setup and what type of opto etc but may be worth trying lower if you do run into issues.
Tried a demo of BobCAD a while back, couldnt work it out as no info at the time, might be now. Asked sales guy when he phoned he said email the iges and he would do a vid showing me how to do it, he sent a screenshot of it but no vid and no explanation. Went with Dolphin CADCAM and like it a lot for the lathe. Well the CADA side is clunky and I dont use it but CAM side I like for Turn.
Hood