Hello Guest it is May 11, 2024, 01:07:16 PM
Profile Guest

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Topics - jjenks0

Pages: 1
1
General Mach Discussion / Any one used xylotex boards to upgrade an EMCO lathe?
« on: May 01, 2009, 01:00:37 PM »
I have an older EMCo lathe that I am currently using Welturn on, I bought a Xylotex board to upgrade to a PC and then use Mach II. Any one done this or have ideas how to hook the board up?

Thanks.

Jack

Pages: 1