1001
General Mach Discussion / Re: Steppers DEAD!
« on: March 12, 2008, 01:29:32 AM »
Hi, H-Wheeler
Most of your pic's don't show up hear.
If you have the mill power on and as you say, When i startup the computer the steppers wherl and move, then there trying/working as the printer port is in a test state.
If your UP, Send me a Personal Msg. with your Phone #, I'll give you a call now, If not i'll call tomorrow after 9:00 pm fla time.
Thanks, Chip
Most of your pic's don't show up hear.
If you have the mill power on and as you say, When i startup the computer the steppers wherl and move, then there trying/working as the printer port is in a test state.
If your UP, Send me a Personal Msg. with your Phone #, I'll give you a call now, If not i'll call tomorrow after 9:00 pm fla time.
Thanks, Chip