4731
General Mach Discussion / Re: Hesitation at intersections
« on: October 31, 2010, 07:07:48 PM »
I've seen it stop on some tangent arcs and not stop on others.
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
But it produced the white horizontal segment in the compensated toolpath,
or a spiral (the purple line) for the uncompensated path. Both seem to be wrong,
in that Mach3 manual mentions nothing about spirals and OTOH if spirals are
valid result for G2/G3 moves, why is the compensated spiral suddenly a
horizontal move?
The card itself works fine under windows 7 but what u cannot do in windows 7 is change the card to EPP and as far as i understand Mach3 needs it to be in this mode.
Not sure why it should be on incremental rather than absolute.
Richard