3671
General Mach Discussion / Re: Milling a cone
« on: December 23, 2005, 08:06:57 AM »
Here is an example of a program that would do that :
G00 G90
X0.0000 Y0.0000
Z.1000
F30.0
G01 Z0.0000 X0.0000
M98 P0100 L360 (Call The sub and run sub 360 times) <-- fixed the G98 to M98
G90 G00 Z1.00
M30
O0100
G90 (Abs mode)
G01 X-2.0000 Z-1.0000
G91 (Inc mode)
A0.500 (Do inc move)
G90
G01 X0.0000 Z0.000
G91
A0.500
G90
M99
IF you have any questions please feel free to ask, But this will give you a place to start
G00 G90
X0.0000 Y0.0000
Z.1000
F30.0
G01 Z0.0000 X0.0000
M98 P0100 L360 (Call The sub and run sub 360 times) <-- fixed the G98 to M98
G90 G00 Z1.00
M30
O0100
G90 (Abs mode)
G01 X-2.0000 Z-1.0000
G91 (Inc mode)
A0.500 (Do inc move)
G90
G01 X0.0000 Z0.000
G91
A0.500
G90
M99
IF you have any questions please feel free to ask, But this will give you a place to start