Messages

1461

LazyCam (Beta) / Re: Here is the new GUI :) Lcam rev ->The Next One

« on: April 16, 2007, 11:14:24 PM »

In addition to the nicer graphics and toolbars, itll load things we never could before. Seems pretty much all ACad files are good now as well.. Be an interesting year for LCam, its getting past puberty,
wont be long till its a babe magnet.

Art

1462

General Mach Discussion / Re: backlash compensation going haywire

« on: April 10, 2007, 09:22:17 AM »

Hi:

 Actually, Backlash works in CV now as well. Set your config/general shuttle accel to .1 , see if that makes a difference. It will seem as if there is too much backlash, but thats only because backlash now ramps to zero before
applying backlash. Its now safe in all runs, but the setting of that accel will setermine how long it tales to ramp to zero.

Art

1463

General Mach Discussion / Re: mach 3 rev2.031 works OK but mach 3 rev2.060 Feed rate problem

« on: March 27, 2007, 10:32:28 AM »

Hi:

 Havent seen that before. Does the commanded feedrate DRO also lower?

Art

1464

General Mach Discussion / Re: Losing Position

« on: March 19, 2007, 01:48:45 PM »

Hi:

 When you say you swapped cables and the problem followed the cable, what cables? The motor power?

Art

1465

Show"N"Tell ( Your Machines) / My workplace..

« on: March 15, 2007, 01:49:35 PM »

Hi:

  Thought you might like to see my workplace..

Art

1466

General Mach Discussion / Re: Losing Position

« on: March 13, 2007, 09:54:57 PM »

Hi:

 Have you tried running in Sherline mode as yet? Id be interested ot know if it loses position in that mode..

Art

1467

General Mach Discussion / Re: Losing Position

« on: March 12, 2007, 09:53:08 PM »

Mike:

 Does it lose at 25Khz, you should never go higher than 25Khz unless you have a perfectly workign system.. ?

Art

1468

General Mach Discussion / Re: Acceleration problem

« on: March 03, 2007, 09:47:43 AM »

Hi:

 Feedhold on scale is fioxed now for the next version. Thanks for that report, I had never tried in in scaled mode..

Art

1469

JetCam screen designer / Re: List of Jetcam requests :)

« on: March 01, 2007, 06:14:37 PM »

Hi Stan:

 We'll help with that with anything you need. Once your done Ill add feature support as needed, and as I can. Delaing with the Screen background can be torublesome as its a CFromView, and their notorious for bad messageing when it comes to backgrounds. But I think we'll be able to add whatever features need to be done..

Art

1470

JetCam screen designer / Re: List of Jetcam requests :)

« on: February 18, 2007, 02:34:44 PM »

Hi Stan:

 It doesnt. Though one can use an invisable button, and a two state LED on top of it to do the same thing. Buttons themselves merely shrink when pressed.
But two state LEDs act just like a two state button.. Just more of a pain to set up cuz you need script in the button to toggle the LED state, unless the LED is a system LED so it changes by itself.. For example, a Reset/Safe button can be done by using a two state ESTOP led, one that says Safe, one that says RESET, an invisable reset button will then work as a two state button..

Art