4891
General Mach Discussion / Re: Nagging software issue
« on: July 18, 2010, 10:34:11 AM »
I use plastic nuts from www.dumpstercnc.com and lubricate them with a light oil. I use pneumatic tool oil.
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Another question, 10 tpi, max velocity of 60 ipm is a motor max rpm of 600, according to the manufactor graph the motors have a max rpm of 2500, I know that the toque goes way down but I should easily be able to get twice the velocity that I'm getting............