15901
General Mach Discussion / Re: Fit a MPG to lathe and mill
« on: April 16, 2010, 03:45:30 AM »Great but how do you wire them up etc
If you are using the parallel port then all you do is connect the A channel to one spare input pin and the B to another and if possible take the power for the MPG from your breakout board as well. Then all you do is go to Config menu, Ports and Pins then Encoder/MPG page and set MPG1 up to the port and pin numbers you have chosen for your A and B channels. You can then go to the Functions Config menu and Calibrate MPG and go through the steps there, remembering to save before you exit.
Hood