24121
General Mach Discussion / Re: controlling VFD with mach
« on: December 12, 2007, 01:51:38 PM »
OK, if you are using two relays then you can leave the M3, M4 and M5 the way they were previously eg M3 was DoSpinCW()
Then go to Ports and Pins then Spindle Setup and make sure you have the Outputs for CW and CCW entered in the boxes and also that you have the Disable Spindle relays box unchecked.
Hood
Then go to Ports and Pins then Spindle Setup and make sure you have the Outputs for CW and CCW entered in the boxes and also that you have the Disable Spindle relays box unchecked.
Hood