871
General Mach Discussion / Re: Offset dont add up
« on: July 13, 2020, 07:00:29 AM »
Hi,
Perhaps take a look at the method I use for Tool Position Setting; http://www.tweakie.byethost10.com/17.htm
(Use the Screen Editor to add a VB button to your screen that contains the offset between your crosshair and cutter. Clicking the on-screen button moves the cutter by that amount).
Tweakie.
Perhaps take a look at the method I use for Tool Position Setting; http://www.tweakie.byethost10.com/17.htm
(Use the Screen Editor to add a VB button to your screen that contains the offset between your crosshair and cutter. Clicking the on-screen button moves the cutter by that amount).
Tweakie.