Ok if you cannot use the Var monitor or have access to the VB editor?
The only other way I know of is IF the version that Tormach uses supports a teh correct XML version then
From the MDI type #501=#130 and press enter. That will transfer the value of #130 OVER TO #501.
#501 is stored in the xml as a persistant value so when you shut down mach you can open the xml and go down to var 501 and see the value.
NOW this only will work IF the tormach version has the newer feature of persistant Vars 500-600.
Other than that I do not know of a way.
Hope that helps