19851
General Mach Discussion / Re: limit switches/ estop?
« on: March 13, 2009, 07:30:19 PM »
Debounce ideally should be zero but from the looks of it you will be struggling to get that. The default of Mach used to be 500 not sure what it sets as now on a fresh install/profile.
Yes, if you have 2 (or 3 ) switches in series for the Z axis then enable them all and set all to the same port and pin, you can put any amount of NC limits in series so you could have all axis on the same Input pin.
Hood
Yes, if you have 2 (or 3 ) switches in series for the Z axis then enable them all and set all to the same port and pin, you can put any amount of NC limits in series so you could have all axis on the same Input pin.
Hood