ha, i do some of my best work when there are no witnesses....
after close inspection i found the pids at 50,0,0.
i ran wdsk and played untill i got good looking curves on all three axis.
now i am spot on, but i think i have a little backlash on the y
a concern i have is that movement with the mpg now is pretty noisy but running gcode seems well behaved..and less noisy.
i found the video tutorial on using the wdsk to tune the servos on galils website and it was very helpful.
i think i have decent tuning profiles based on that info.
another small issue i have is that while running some test code mach3 would stop mid-code. simply stop as if there was an optional stop
but there wasn't. no errors that i could find. i can only resume the program if i stop the program then hit the start from here and resume.
the problem did not duplicate running the same program consistently. (roadrunner)
thanks for the help, i can actually use the mill now......1 1/2 year trying to get camsoft to work.....threw that out.....5 months with mach and i'm makin chips......