3831
General Mach Discussion / Re: What's your fastest feed rate for your mill/parallel port.
« on: January 12, 2012, 11:28:02 AM »
Ray, he's using servos
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
It appears to me that recent revisions have catered for those that shout the loudest and have not really been for the good of all.
but I still have the 500 lines limit which message "End program" when arriving at the line 500 and that with all G-code I tested.