1291
General Mach Discussion / Re: Set Override/ Feedrate to 100%, or ignore it completely during auto zeroing.
« on: April 15, 2016, 09:01:08 AM »
Try:
SetOemDRO(821,100)
SetOemDRO(821,100)
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
I appears on a screen "clearance plane must> 0- Please reset"
But I can not change zero "clearance plane", I can not activate "Manual spindle control" or "machine coordenates".
When "use safe Z" I get a code that also do not understand how to activate.
I can not activate "Manual spindle control" or "machine coordenates".
Could you help me somehow? Is there any manual settings? And if it is not too much to ask ... is not there something in Spanish?