8901
General Mach Discussion / Re: Motor "Sometimes" goes in Wrong Direction while Tuning
« on: March 18, 2009, 03:33:08 AM »
Hi Jamie,
Sorry I just assumed you would know.
A breakout board (BOB) is where the LPT connection from the computer joins with the machine. Some BOB's are 'active' in so far as they incorporate opto isolators and are powered 5 Volts. The Gecko controller already incorporates opto isolators on its inputs and sometimes behaves oddly if active BOB's are used. For Gecko operation a passive BOB is usually used.
Hope this explains what I was getting at and once again sorry for posting a reply that was not fully explained.
Tweakie.
Sorry I just assumed you would know.
A breakout board (BOB) is where the LPT connection from the computer joins with the machine. Some BOB's are 'active' in so far as they incorporate opto isolators and are powered 5 Volts. The Gecko controller already incorporates opto isolators on its inputs and sometimes behaves oddly if active BOB's are used. For Gecko operation a passive BOB is usually used.
Hope this explains what I was getting at and once again sorry for posting a reply that was not fully explained.
Tweakie.