3681
General Mach Discussion / Re: My CNC 2030 stops following G codes
« on: March 19, 2016, 09:23:11 AM »
You perhaps need to provide some more detail about the problem and exactly what is happening.
Just some things to check…
Is your Gcode commanding the move ?
The tool is not tightly gripped in the collet / chuck and moves during use.
The Z axis is loosing steps (stalling) on the upward (+Z) moves.
Loose coupling on the Z axis motor.
Tightness or binding in the Z axis travel.
Tweakie.
Just some things to check…
Is your Gcode commanding the move ?
The tool is not tightly gripped in the collet / chuck and moves during use.
The Z axis is loosing steps (stalling) on the upward (+Z) moves.
Loose coupling on the Z axis motor.
Tightness or binding in the Z axis travel.
Tweakie.