3691
General Mach Discussion / Re: Tool change macro issues....I'm about ready to go to linux
« on: November 30, 2013, 04:19:11 PM »
OK the macro is fine, occasionally I have seen them get corrupted.
Regarding the Zero RPM, I have seen the DRO get set to Zero when pressing the Reset button, in fact it screwed up a Brain I had and I had to resort to the macropump to set it.
Suppose your answer is to set the pulleys to 0 for min unless that would cause other issues?
Hood
Regarding the Zero RPM, I have seen the DRO get set to Zero when pressing the Reset button, in fact it screwed up a Brain I had and I had to resort to the macropump to set it.
Suppose your answer is to set the pulleys to 0 for min unless that would cause other issues?
Hood