1961
General Mach Discussion / Re: Changing Spindle Speed
« on: July 11, 2018, 08:47:22 AM »
If you are using Mach3 then the delay will not help - the axis motion will, I think, always be start, stop.
Tweakie.
Tweakie.
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
I'm sure the CycleStop is the right way to stop work. The instantaneous stop of the step pulses is incorrect. I have never encountered the error of servomotors at a stop, only in mach3 and mach4.
Also the new C35S board is a slightly different layout, so I had to replace the ethernet connectors that go to the motor drives with longer ones so they would reach.