3021
General Mach Discussion / Re: Lathe Threading - RPM inconsistent
« on: February 23, 2014, 02:11:08 PM »
If the pulse frequency is way out compared to the kernel and it has just recently happened, then I would say hardware could be the likely culprit.
Look at the mobo and see if any caps are bulging, look in the BIOS and see if the voltages and temps are close to where they should be. If you are having crashing problems with the computer (not sure if you are or not) then could be memory.
Hood
Look at the mobo and see if any caps are bulging, look in the BIOS and see if the voltages and temps are close to where they should be. If you are having crashing problems with the computer (not sure if you are or not) then could be memory.
Hood