18731
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
In turn I could find no way or dro that stored the offset number that was applied to the turret durring the tool change command.It is also something I have wanted for a long time and Brian will be adding it when he gets working on Turn.
In milling this is not much of an issue, but in turning sometimes you dont use the same offset number as tool number.
asper : tool 1 with a .031 nose radius say T0101
or tool 1 with a .015 nose radius say T0111
If you can please add this if I am not overlooking it.
Thanks Drew