14601
General Mach Discussion / Re: New Parallel Port not working
« on: September 26, 2010, 11:14:31 AM »
Not really but its the only thing I can think of, your xml looks fine apart from Pin 16 being both spindle Step and Dir and also OutPut 1. I am sure I mentioned that to you before and you said that was the way it was meant to be with your spindle hardware, so its not a problem. Even if it was wrong it should not stop you getting movement on the axis.
If you go to device manager then Ports and look at your PCI cards resources tab is the address cc00?
Hood
If you go to device manager then Ports and look at your PCI cards resources tab is the address cc00?
Hood