Hi all,
I'm having problems setting up the index pulse and i'm looking for a little help.
Its counting more pulses than it should, maybe about twice as many and is not linear.
I've tried Index Debounce and any value above 0 seems to have the same effect, it shows 135 RPM no matter what my spindle speed is.
I'm using an optical sensor (Optek OPB 917 BZ) with a 60mm diameter disc and one 10mm slot.
I read on this forum that its necessary to enable Spindle Relays even if they are not used, I tried this and it didnt seem to make a difference.
Is it necessary to run Spindle Calibration Test to get the Index Pulse to work properly?
I'm using the Demo version R3.043.022 Lockdown also tried the R3.043.045 Development but same results.
any advice or help would be much appreciated.
Regards,
Simon