1361
CS-Lab / Re: Retrofit CNC Bulleri FPM 2813-Osai controll with CSMIO-IP-A
« on: May 24, 2015, 07:30:53 PM »
Try reversing the encoder in the CSMIO plugin and see if that helps.
You will have to find the issue with the Enable though, the axes should never move if the drive is not enabled.
It is best to have properly shielded wiring on any low voltage signal, if the signals are differential and twisted in their respective pairs then the shielding is less important however it is still a good idea to shield correctly.
The output should not be an issue as the drive is capable of outputting more than the IP-A requires, assuming I am understanding what you are meaning of course
Hood
You will have to find the issue with the Enable though, the axes should never move if the drive is not enabled.
It is best to have properly shielded wiring on any low voltage signal, if the signals are differential and twisted in their respective pairs then the shielding is less important however it is still a good idea to shield correctly.
The output should not be an issue as the drive is capable of outputting more than the IP-A requires, assuming I am understanding what you are meaning of course
Hood