1721
General Mach Discussion / Re: Lathe Threading Wizard Rev 1.17
« on: January 30, 2014, 10:39:24 AM »Quote
I have a few extra Hall effect switch sensors laying around, and some magnets,
I use a Hall effect sensor and below is a link to how it's mounted. Works great,but, if one needs to purchase new it's cost
may be pricey.
http://www.machsupport.com/forum/index.php/topic,12484.msg82818.html#msg82818
You should check the spec info for the sensors you have. The sensor must be able to proivde / sense index at spindle speeds you will be using.
Can't remember details but a few sensors I have were not adequate.
RICH