Ahh. Fixtures. That is something that I haven't toyed with. That may actually solve the dro jumping to a negative of the tool offset and then traveling back to zero to cut at the offset. That is the only thing I didn't like about it. I couldn't watch the DRO's and adjust my code accordingly.
I can't get Dolphin to produce code that I can use.
It must be tuned up by hand.
Since all my tools are on a gang setup, there is no need for basic parts to have a tool change.
I ignore tool change in M3T for these parts. DT puts a spindle stop M5 in at each tool.
Then at each tool, it goes to safe Z and then back to zero using a G28. No idea how that gets in there.
Since all three tools are not at zero in Z, they cannot travel in X at zero to the offsets. They have to do traveling at Z1. I need single axis moves instead of both.
I am wondering if Exact Stop might help there?
Something Odd that M3T is doing too with G83.
The first deep drill cycle I use works great.
After the first part is parted, the second deep drill cycle is doing stuff it shouldn't. Like initially plunging to new cut depth at full rapid. That's okay, but then it will G01 back to zero, then rapid back a few times until if finally starts to do the deep drill cycle like it should. I'll try to get a video of it.
I did find the zip file on here concerning this and did install the files in the correct folder, but not getting different results yet.
I still have a lot to learn about both M3T and DT, but I am producing parts again.