1461
General Mach Discussion / Re: Bridgeport Knee Mill Conversion?
« on: July 27, 2016, 01:17:04 PM »
Odd - the error numbers tonight were exactly the same as yesterday - x73,y60,z56 and did not change at all while i was messing about so they are perfectly stable now and i am happy. Where the errors initially come from i don't know - maybe starting up the CSMIO with the drives turned off ??
Anyway the cable fixed it
Fault inputs - on the drives the outputs are opto-couplers with common ground so i guess sinking outputs.
I need to connect these to the input on the CSMIO, do i connect the input+ to 24v and the input- to the drive output?
I think thats correct.
Anyway the cable fixed it
Fault inputs - on the drives the outputs are opto-couplers with common ground so i guess sinking outputs.
I need to connect these to the input on the CSMIO, do i connect the input+ to 24v and the input- to the drive output?
I think thats correct.