5171
General Mach Discussion / Re: Axis movement problems while running code.
« on: June 25, 2013, 05:44:56 AM »
Do you get any message in the status window at the bottom of the screen ?
Tweakie.
Tweakie.
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Is it possible to run commands as you think m10p1 with usb? I do not understand what I should do.
I'd like to have a second timer as well. The average time from program start to program start. That way you'd get an idea of the total time per part, including you sips of coffee, reloading, browsing forums while the machine sits etc.