6441
General Mach Discussion / Re: How to recover from power interuption?
« on: September 16, 2010, 11:34:26 AM »
Looking at your accuracy requirements the ONLY way to do this is to run a UPS "AND " a very large battery bank. That way there is NO interuption of cut.
With your resolution requirement you cannot even "stop" the program without effecting the finish cut. SO the machine must remain running thru the power outage.
It would be very hard to create a macro to be to retract the cutting bit in a method that would not cause harm to a finish cut. COULD be done but very complicated.
(;-) TP
With your resolution requirement you cannot even "stop" the program without effecting the finish cut. SO the machine must remain running thru the power outage.
It would be very hard to create a macro to be to retract the cutting bit in a method that would not cause harm to a finish cut. COULD be done but very complicated.
(;-) TP