Hi Guys,
I just dwnlded the drill wizard and I have an issue, hopfully you can straighten me out.
First, just to make sure I loaded it correctly, Drillwiz shows up as a wizard under the wizard button, not under the new fangled button, is this correct?
I am running a Tormach 1100 using Mach3 version R3.042.029.
I am unable to control the spindle RPM, when I type a number into the RPM box under the spindle & coolant buttons, I can type it in, but as soon as I hit enter the number goes to zero. When I select M3 or M4 the spindle starts, but runs at the slowest possible speed?
I'm attaching a screenshot in case it might help.
Regards
Terry May