1831
General Mach Discussion / Re: Work offsets 101 ;)
« on: April 11, 2016, 04:41:34 PM »
Hmm, i tried adding it to the process list in sheetcam, last item after all the cuts etc and this is the end code from a job...
N27150 (Operation: Insert code snippet Code: Apply Standard Offset G54)
N27160 G00 Z20.0000
N27170 G54
N27180 G00 X87.7841 Y384.6574 Z20.0000
N27190 X0.0000 Y0.0000
N27200 M05
N27210 M05 M30
Seems it is calling G54 as needed but it then issues move commands which would be in the wrong offset - this is wrong is it not??
Yes a post edit may be needed??
N27150 (Operation: Insert code snippet Code: Apply Standard Offset G54)
N27160 G00 Z20.0000
N27170 G54
N27180 G00 X87.7841 Y384.6574 Z20.0000
N27190 X0.0000 Y0.0000
N27200 M05
N27210 M05 M30
Seems it is calling G54 as needed but it then issues move commands which would be in the wrong offset - this is wrong is it not??
Yes a post edit may be needed??