5401
General Mach Discussion / Re: Indexing Problem with R.3.042.032
« on: November 16, 2009, 08:33:12 AM »
Peter,
The only problem i am having is at a low rpm of 55 and all the others to 2300 are fine. The DRO shows 55 rpm but in the Threading Diagnostics the true rpm value is all over the palce but the application rpm is ok. Art is aware of this and also the rpm not going back to a zero value.
If you manualy turn on the motor then you need to uncheck the relay control box in config>ports&pins>spindle for now.
RICH
The only problem i am having is at a low rpm of 55 and all the others to 2300 are fine. The DRO shows 55 rpm but in the Threading Diagnostics the true rpm value is all over the palce but the application rpm is ok. Art is aware of this and also the rpm not going back to a zero value.
If you manualy turn on the motor then you need to uncheck the relay control box in config>ports&pins>spindle for now.
RICH