Trying to setup my Thinkpad to run my newly built mill. It's an R40. 2 GHz with 512 MB ram.
The driver test works fine in 25,000 freq mode, but when I try the 35,000, I get an error that reads "Could not locate missing Vectors."
The next time I try the driver test, it runs on 25,000 frequency.
I tried the special driver with the same results.
Will I be forced to just use the 25,000 freq mode? Is the cpu too slow to go any faster? I did a few searches and saw this a couple times, but the questions on those threads were left unanswered. Anyone have any ideas.
It won't be the worst thing to run it slower for the mill, but just really curious about it.
Thanks a bunch.