801
General Mach Discussion / Re: Mach signal delay??
« on: August 26, 2015, 10:50:18 AM »
Best thing to do is make a test cut and LOOK at what it is doing. IF if peirces cleanly then leave it be IF you need to add time add time IF you need to subtract time subtract time . BUT you will find there is a point that Mach3 cannot control it any better. There are about 4 different dwell points that can stack up on you from time to time. Then there is that it will NOT fire the torch(M3) from Gcode problem. But then when you cycle it it works fine. GGRRRR.
(;-) TP
(;-) TP