21371
General Mach Discussion / Re: How to set the modbus output signal??
« on: October 15, 2008, 08:50:12 AM »
heres a screenshot of the settings I have for the PLC.
Hood
Hood
This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.
Hi Guys:
New dev version PoKeys.m3p is in the files section for testing. It will accept
up to 7 encoders, but is untested in that regard. It uses new firmware that you
have to download from poKeys ( PoKeys55) ..
When turning on encoders, you must set them to port#10 in MAch3, and the
encoders used must be numbered from 1 - x in order in the plugin. In other words
if you turn on only #5 and #6 which are MPG encoders, then you need only
encoders 1 and 2 turned on in the pokeys. You dont need to turn on 6 of them and
then only use #5 and 6.
Again, untested except for basic IO. Analogue's .. up to 4 .. are read as well
if available and put in the same spot the G100IO uses ( registers 124 - 127 )
for use by brains. The analogue inputs are all 16 bit.
No analogue out has been added, Ill add that in future when the current encoder
tests and analogue input testing is complete.
Thanks,
Art