Hi RICH, Im reading the manual and doing the LC at same time. finally I got my drawing going in order the way I want to be cut.I did the tool set up. I did the Offset as well, and I can see the offset line outside the part. so im getting there slowly. the only thing stilln need to change its where its start. I can see the tool its position on (0,0) bottom left corner but when it go to the rapid it moves all the way to the other side, how I change it to make start machining on the bottom left corner of the part. I'll keep readding hope I can find it. Also I dont know what I did but first time I try it it was showing one pass (1/2" deep) thats the way I want but then it shows multiple passes . Well thing it going to be lot of reading before I get everything rigth . but as soon as I learn its going to be so easy.
Thak you for all your help
Jaime