14281
General Mach Discussion / Re: Manual button for auto zero
« on: October 22, 2010, 02:22:29 PM »
I do a similar kind of thing, in as much as I run macros via external buttons. Scott Scheafers MachMad plugin allows you to assign a User LED to a macro and when the LED is seen the plugin will run the macro that you have designated.
So what you would do is have your autozero named as a macro ( eg m1234.m1s) and placed in your profiles macro folder. You would then set up the plugin to look out for your LED and tell it the macro to run.
You could also likely do this via a macropump, just have the macropump look for a LED and then do the macro when its seen.
Hood
So what you would do is have your autozero named as a macro ( eg m1234.m1s) and placed in your profiles macro folder. You would then set up the plugin to look out for your LED and tell it the macro to run.
You could also likely do this via a macropump, just have the macropump look for a LED and then do the macro when its seen.
Hood