4251
General Mach Discussion / Re: Y axis won't move in Job Step but work fine in Continous Mode?
« on: September 21, 2013, 02:35:31 PM »
Ok, if DROs are moving that will mean I will have to try and hook up a parallel port and a scope to see if the pulses are being output. They should be as supposedly the DROs get updated from the output of the driver, so if they are moving the pulses would seem to be getting sent.
One thing you may wish to try is increase the Pulse Width and Dir on motor tuning to maybe 10 or 15 and see if that helps.
Hood
One thing you may wish to try is increase the Pulse Width and Dir on motor tuning to maybe 10 or 15 and see if that helps.
Hood